Genie intellicode keypad reprogram8/28/2023 ![]() Check if the Safe-T-Beams red LED light is flashing. ![]() Make sure ONLY the safe-t-beams that came with this garage door opener are installed.If it is a NEW installation, check the postion of the door arm.Garage door starts down, then STOPS and goes back up OR Safe-T-Beam System malfunction If the lightbulb was the problem, a Genie LED lightbulb will resolve this issue.Remove energy efficient bulbs, they can interfere with the remote signal.Check for items that you recently changed or added in or near the garage that may interfere.Eliminate possible competing signals in the surrounding area (radio etc.).Remote has less than 25 feet operating range Replace the remote battery if neccesary.Check all remotes (if all the remotes and wireless devices stopped working at the same time, this could indicate the circuit board needs replaced).Garage door opener works from the wall control, but NOT from the remote ![]()
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |